AnalysIR now provides support for the PSOC 4 Prototyping kit from Cypress. Effective immediately users of AnalysIR can use the kit to act as an Infrared source for AnalysIR. The PSOC 4 Prototyping kits are available from Cypress and via their global distributors for just US$4 plus shipping. To use the kit with AnalysIR you will also need an IR Receiver and an optional IR Learner, which can also be purchased with AnalysIR. Initially, the PSOC Firmware is available on request and will be included as part of the installation package in a future release.
A new user of AnalysIR from the Netherlands, wanted to get the AnalysIR firmware working on Teensy 3.x . Although this has not been officially supported, we were happy to support his efforts knowing that it would most likely be a relatively easy exercise, based on past experiences. Needless to say, he was successful in decoding Infrared signals with AnalysIR within a short space of time. Prompted by his interest, we ordered our own Teensy 3.1 to add to our growing collection of 40+ MCUs and although
Teensy support is in beta for now, it will be oficially supported for AnalysIR from our next release. In the meantime, users of AnalysIR can just contact us for a copy of the Teensy sketch (firmware).
Teensy 3.x now joins a long list of devices supported for use with AnalysIR, including: Continue reading Teensy now supported for AnalysIR
Dublin, Ireland – 31st January 2014. We are happy to announce the latest ‘New Year’ release of AnalysIR to all our backers & supporters. Since the completion of the crowd-funding campaign on Indiegogo we have added over 125 updates and enhancements to AnalysIR, with more to come.
A major highlight of this release is full AnalysIR support for USB IR Toy from Dangerous Prototypes (V1 & V2 hardware) for decoding and resending IR signals at all common modulation frequencies. In our opinion, AnalysIR is now the premier GUI supporting DP’s IR toy, not to mention the Arduino, RPi, MSP430 F5529 LaunchPad (beta) and more. A selection of enhancements in this latest release, include: Continue reading Latest ‘New Year’ release of AnalysIR with full support for USB IR Toy and more.
Here are some photos we captured, of a sample of our MCU test rigs and custom PCB for AnalysIR.
The photo above shows some of our test setup for Arduino, Raspberry Pi, TI MSP430 LaunchPad and the (big) baby of them all the USB IR Toy. The small red custom PCBs are ones we had made via Elecrow which worked out great. So instead of just using solderless breadboards we now plug these ‘half shields’ directly into the Arduino header, or in the case of the RPi using a ribbon cable. The USB IR Toy already has the IR receivers on board and doesn’t require this PCB.
We should also be able to hook up the LaunchPad to this board using headers. So once we receive the full set of headers, we ordered on-line, we will have all our test setups much neater and more reliable. Previously, we used solderless breadboards, as can be seen in the photo attached to the LaunchPad. Continue reading Testing AnalysIR with a custom PCB
Today we issued a test release of AnalysIR, supporting V1 & V2 USB IR Toy loaded with firmware V22. If you have an IR Toy and want to test it out, leave a message with your email in the contact form at the top. Naturally, this is available only to backers with AnalysIR. You can support our project and get a copy of AnalysIR via the option at the top of this page.