In Part 1 of this series, we demonstrated how to send signals using simple Infrared PWM on Arduino. In this Part 2 post we look at sending RAW IR signals – specifically a RAW NEC signal and a longer RAW Mitsubishi Air Conditioner signal. We have also improved the method shown in Part 1 due to some issues we identified when sending ‘real’ signals versus the ‘test’ signal we used before. (More on that later). In Part 3, we will take the signals from this post and show how to send them using their binary (or Hex) representation, which saves lots of SRAM.
This post is the second in a two-part series about Reverse Engineering AC Infrared protocols. This time we look at the Mitsubishi Air Conditioner IR Protocol. The project was undertaken by two of our users in France (Vincent & Mathieu), with the help of AnalysIR, who collaborated to reverse engineer this Mitsubishi and previously the Panasonic AC Infrared protocol, both examples of the more challenging AC Infrared protocols. Not only did they identify the individual field codes & checksum but also provided some impressive documentation. Detailed information is available via GitHub which is linked below. This 288 data bit Mitsubishi AC Infrared protocol is composed of two consecutive frames. Both frames are always identical for each signal sent. In common with most AC units the complete settings are sent with every IR signal (temperature, fan, swing etc…). AnalysIR was used to record and turn the signal into HEX/Binary format from which the reverse engineering of the individual fields was tackled.